15
Pinpointing
When you found a promising signal while detecting, you can
use the Pinpoint-function to determine the exact position
of the object more accurate. To do so, move the coil to
a place without a signal and start to press the Pinpoint-
button. While holding it down, perform a cross motion
above the target, as shown in the picture. The louder and
more stable the sound is, the nearer the object is to the
middle of the coil. The number on the display shows how
many cm there are between the coil and the target.
Digging
When you have found an object and identified its position as exact as possible, dig a
small hole around the target. If you have trouble finding it, a loose Pinpointer like the
Quest XPointer is helpful. After you found the object, use your detector again to be
sure that there is nothing left. At last, fill up the hole again to prevent other people or
animals from hurting themselves.
Charging
Connect the included magnetic charging
cable with the magnetic charging port at
the backside of the control unit. Plug the
other end of the cable into a power plug
and connect it to the power supply.
9. Operation