DR4300 Owners Manual
Removing the PCIe card holder
92
a. processor
b. thermal grease
c. thermal grease syringe
3. Place the heat sink onto the processor.
4. Tighten one of the four screws to secure the heat sink to the system board.
5. Tighten the screw diagonally opposite to the first screw you have tightened.
NOTE:
Do not over-tighten the heat sink retention screws when installing the heat sink. To prevent
over-tightening, tighten the retention screw until resistance is felt, and stop after the screw is seated.
The screw tension should not be more than 6 in-lb (6.9 kg-cm).
6. Repeat the procedure for the remaining two screws.
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the processor information matches the new
system configuration.
3. Run the system diagnostics to verify that the new processor operates correctly.
PCIe card holder
The PCIe card holder can be extended to support a full length PCIe card. This will prevent any damage to the
card that may occur due to its length.
Removing the PCIe card holder
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Summary of Contents for DR4300e
Page 1: ...DR4300e System Owner s Manual ...
Page 181: ...DR4300 Owners Manual 181 Index ...
