Quell on
©
• 5639 Jefferson N.E. • Albuquerque, New Mexico 87109 • (505) 243-‐1423 •
February 17, 2012
©
2012 Quell Corp.
US Patent No. 5,686,697
Step 3
PARTIALLY Insert the EESeal
Slightly cup the EESeal so that Pinhole A (or
pin 1) can be easily slipped onto the
corresponding pin in the host connector.
Double-‐check that the corresponding EESeal
pinholes are going over the correct pins in the
connector. Gently use your Iingertip to push
the EESeal down just over the tip of the pin,
no further. Now simply press the rest of the
pins into the EESeal pinholes in the same
manner. To make the EESeal go on easily,
notice that the EESeal is intentionally
oversized, so your pressing action should be
towards
(not away from) the pins already
completed. Do not attempt to push the EESeal
down any further than just over the tip of the
pins.
Step 4
Fully Insert & Seat the EESeal
First, conIirm that you can see the tip of each
and every pin slightly poking through its
corresponding EESeal pinhole (if not,
complete step 3 before proceeding). The
EESeal can be fully inserted and permanently
seated by simply mating the connector pair.
Now check the EESeal to ensure it is Ilat at the
bottom of the connector, with no folds along
its edge or interior. It should appear like it
belongs there. If you notice anything unusual,
please contact us.
Lightly push the “A”
pinhole onto
just
the tip
of pin A
Partially insert just the
tip
of the pins into the
pinholes
Seat the EESeal so
all of the pins are
fully exposed
Questions?
Please call
(505) 243-‐1423
or email [email protected]
for assistance.
