LTE Module Series
EP06&EG06&EM06 GNSS AT Commands Manual
EP06&EG06&EM06_GNSS_AT_Commands_Manual
16 / 29
Parameter
2.3. AT+QGPS Turn on GNSS
The command is used to turn on GNSS function. Currently it only supports turning on GNSS in
Stand-alone
mode (that is,
<gnssmode>
=1). When
<fixcount>
is 0, GNSS will fix position continuously,
and it can be turned off via
AT+QGPSEND
.
When
<fixcount>
is non-zero and reaches the specified
value, GNSS will be turned off automatically.
Reference
<deletetype>
The type of GNSS assistance data to be deleted.
0
Delete all assistance data except gpsOneXTRA data. Enforce cold start after
starting GNSS.
1 Do not delete any data. Perform hot start if the conditions are permitted after
starting GNSS.
2 Delete some related data. Perform warm start if the conditions are permitted after
starting GNSS.
3 Delete the gpsOneXTRA assistance data injected into GNSS engine.
<errcode>
Integer type. The error code of the operation. If it is not 0, it is the type of error. Please
refer to
Chapter 4
for details.
AT+QGPS Turn on GNSS
Test Command
AT+QGPS=?
Response
+QGPS: (1-4),(1-255),(1-1000),(0-1000),(1-65535)
OK
Read Command
Read current GNSS state
AT+QGPS?
Response
+QGPS: <gnssstate>
OK
Write Command
AT+QGPS=<gnssmode>[,<fixmaxtim
e>[,<fixmaxdist>[,<fixcount>[,<fixrate
>]]]]
Response
OK
If there is any error related to ME functionality:
+CME ERROR: <errcode>
Reference
