GMT200 User Manual
TRACGMT200UM001
-12 -
Table 7: Definition of Device status and LED
Note:
1 - CEL LED cannot be configured.
2 - GPS LED and PWR LED can be configured to turn off after a period of time using the
configuration tool
3 - Fast flashing is about 60ms ON/ 780ms OFF
4 - Slow flashing is about 60ms ON/ 1940ms OFF
LED
Device status
LED status
CEL
(note1)
Device is searching GSM network
Fast flashing
(Note3)
Device has registered to GSM network.
Slow flashing
(Note4)
SIM card needs pin code to unlock.
ON
GPS
(note 2)
GPS chip is powered off
OFF
GPS sends no data or data format error.
Slow flashing
GPS chip is searching GPS info.
Fast flashing
GPS chip has gotten GPS info.
ON
PWR
(note 2)
No external power and backup battery voltage is
lower than 3.35V.
OFF
No external power and backup battery voltage is
below 3.5V.
Slow flashing
External power in and backup battery is charging
Fast flashing
External power in and backup battery is fully
charged
ON
FCC Warning:
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment .This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body.
This transmitter must not be co-lo cated or operating in conjunction with any oth er antenna or
transmitter.
