QubicaAMF 612-051-001, Owner'S Manual

Page: 51 / 155

TMS STRING PINSPOTTER
OWNER’S MANUAL
400-051-010-01 Rev. Date: 7/17
Page 2-11
5. Adjust the strings with the take-up reels (pull the reel out from the reel arm and
rotate) so that the pins just touch the stabilizing rings on the underside of the lower
table, are all at the same height, and so that the top of the reel arms are still touching
the rear reel arm stopper (see image below). Pull the string towards the drawbar to
identify the proper reel to adjust. Use one hand to pull on the string, lifting the pin up
to the table while adjusting the reel with the other hand. This will take the tension off
the string to make adjusting the reel easier.
Figure 2-1, Reel Arm Position
6. When the string adjustment is complete, close and lock the top and front covers of the
machine. Remove LOTO constraints from the power connector. Turn the AC power
ON and press the HOME pushbutton on the control box keypad. Enter password
(down>left>up>right>up>left>down) if a password is requested. Then press TRBL
CLR. The drawbar will retract from the stop pins and return to the HOME position
again and stay there for 10 seconds.
7. During the 10-second wait period, pull the stop pins out of their holes and let the
machine finish the cycle. The machine will perform a pin deck calibration to relocate
the pin deck following a string adjustment.
8. Press the MODE pushbutton on the control box keypad to exit the Mechanics Mode.
Push EXIT to lock the keypad.
Reel Arm
Reel Arm Stoppers
Front Rear