PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
2.18 Spacers and screw joints
In the assembly kit are different spacers included (M3 and M2,5).
On the outer edge of the circuit board are all together eight drills. Here we need the M3,5
mm spacers with external thread and the M3x15 mm spacers.
Order from left to right (Figure 75):
M3x5 mm – circuit board – M3x15 mm spacers
In the middle of the circuit board are six more drills. Four of them are used for the montage
of the Raspberry Pi model B+ / 2 B / 3 B. The rest of the drills are normally not used (they
are for the montage of the “old” Raspberry Pi model B (without “+” or “2” / “3”).
Hold the Raspberry Pi over the board before the montage, so it is easier to see which drills
are the right ones.
The order here is the same as with the M3- spacers:
M2,5x5 mm – circuit board – M2,5x25 mm spacers
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
68 / 75
Figure 75: Montage of the spacers
