First steps
First dreams
Quax
®
First steps
First dreams
Quax
®
www
.quax.eu
23
4. Assembling the wardrobe
Armoire avec deux portes
Wardrobe with two doors
Kleerkast met twee draaideuren
Schrankwand mit zwei Drehtüren
CAMILLE
76 10 04 0xx
Step 1 :
Use the right side
A
, the bottom
D
, the lower bot-
tom profi le
C
, 3 wooden dowels
nr. 1
, 1 connecting bolt
nr.
2
, 1 eccentric cam
nr. 3
and 2 wood screws
nr. 4
Place the side upside down on a fl at surface. Insert two
dowels in the provided openings of the lower crossbeam of
the side frame. Fix the connecting bolt into the lower open-
ing of the wardrobe its frontal leg and a dowel in the opening
just above. Insert the eccentric cam in the provided opening
of the lower bottom profi le. Place this profi le over the con-
necting bolt and the dowel and tighten the eccentric cam.
Push the bottom over the dowels of the ward robe cross-
beam and insert two wood screws in the openings of the
bottom. Tighten these with a screwdriver.
Step 2 :
Use the assembled parts of step 1, the middle
shelves
E
, the upper shelf
F
(with the most holes), 10 wood-
en dowels
nr. 1
, 2 connecting bolts
nr. 2
and 2 eccentric
cams
nr. 3
Insert four dowels in the provided openings of the lowest
free crossbeam, four in the crossbeam above and two dow-
els in the center of the crossbeam there above. Fix two con-
nectng bolts in the openings on the outside of the same
crossbeam. Insert two eccentric cams in the openings on
the underside of the upper shelf. Push all the shelves over
the dowels and connecting bolts. Tighten the eccentric
cams of the upper shelf.
Step 3 :
Use the assembled parts of step 2, the partition
G
, 10 wooden dowels
nr. 1
, 2 connecting bolts
nr. 2
and 2
eccentric cams
nr. 3
Insert four dowels in the provided openings of the lowest
shelf, four in the shelf above and two dowels in the center
of the shelf there above. Insert two eccentric cams in the
openings on the underside of the same shelf. Fix two con-
nectng bolts in the outer openings on the underside of the
partition panel. Place the partition and tighten the eccentric
cams.
