Quasonix QSX-RDMS-RM Series, Installation And Operation Manual, Page: 166 / 190

Rack-Mount RDMS
TM
Telemetry Receiver
151 Quasonix, Inc.
5 Performance Specifications
5.1 RF Input
Each receiver channel is available in multiple band configurations, as shown in Table 11.
Table 11: Band Codes and Frequencies
Model Number
Code
Band Minimum
Frequency
Maximum
Frequency
Default
Frequency
P P band (UHF) 400.0 MHz 1150.0 MHz 400.0 MHz
L Lower L 1435.5 MHz 1534.5 MHz 1435.5 MHz
U Upper L 1755.0 MHz 1850.0 MHz 1755.0 MHz
S S 2200.5 MHz 2394.5 MHz 2200.5 MHz
C
C “Low”
4400.0 MHz 5150.0 MHz 4400.0 MHz
G P and S (Dual band) 400.0 MHz and
2200.5 MHz 1150.0 MHz and
2394.5 MHz 2200.5 MHz
F S and C (Dual band) 2200.5 MHz and
4400.0 MHz 2394.5 MHz and
5150.0 MHz 2200.5 MHz
M Lower L, Upper L, and
S (Tri-band) 1435.5 MHz 2394.5 MHz 1435.5 MHz
R P, Full-L, and S
(Quad band)
400.0 MHz 2394.5 MHz 1435.5 MHz
Q Full L, S, and C
(Quad band)
1435.5 MHz 5150.0 MHz 1435.5 MHz
E P, Full L, S, and C
(Five band)
400.0 MHz 5150.0 MHz 400.0 MHz
The input impedance is 50 ohms.
5.2 Power
The rack-mount receiver requires 100 to 240 VAC, 50/60 Hz power.
5.3 RF Frequency Error
By default, the RDMS™ is capable of acquiring a signal with a frequency error of up to ±100 kHz.
5.4 Bit Error Rate
The RDMS™ meets the following BER limits, when tested with a signal source, which complies with IRIG 106-05.