Quantum ValueLoader DLT VS160, User Manual

Page: 27 / 88

Chapter 1 Installing the ValueLoader
Connecting the SCSI and Power Cables
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 13
2 Attach one end of the SCSI cable (included in the accessory kit) to one
of the connectors on the back panel of the ValueLoader (see figure 8 ).
3 Attach the other end of the SCSI cable to the connector on the SCSI
host adapter or to the connector on the previous device on the SCSI
bus.
4 Attach the terminator to the remaining SCSI connector on the back
panel of the ValueLoader (if the ValueLoader is the last or only
device on the SCSI bus). Otherwise, attach the cable to the next device
on the SCSI bus. Make sure that the last device on the SCSI bus is
properly terminated.
5 Attach the female connector on the power cable to the power
connector on the back panel of the ValueLoader (see figure 8 ).
Figure 8 Attaching
SCSI and Power
Cables
Note: If the supplied SCSI cable does not fit the connector on
your SCSI host adapter, you either have an incompatible
SCSI host adapter or you need to purchase a cable adapter.
Contact your service representative or your SCSI host
adapter manufacturer for information.