Quantum ValueLoader DLT VS160, Product Specification

Page: 30 / 62

Unload Button Functions DLT VS160 Product Specification
3-4 September 2004 81-81275-01 REV A02
3.2 Unload Button Functions
You can use the unload button to unload and eject data cartridges, and for the additional features
shown in the following table. Press and hold the eject button for the time specified in the following
table to activate one of these features. Release the button when the LEDs display the desired sequence.
C
AUTION
The two features noted in the following table will over-write
any data on the data cartridge. Do not use these features if the
data cartridge in the tape drive contains critical data.
Table 3-4. Unload Button Functions
Description
Ready
(green)
Fault
(orange or
clear)
Clean
(orange or
clear)
Media
(orange or
clear)
Hold Time
(seconds)
Normal unload function 0 to 6
Reserved – – – 6 to 9
Enter code load tape mode – – 9 to 12
Reserved – 12 to 15
Reserved 15 to 18
Revert back to normal mode – – – 18 to 21
Read/write diagnostic start.
CAUTION : This feature overwrites any
data currently on the data cartridge.
– – 21 to 24
Reserved.
CAUTION : This feature overwrites any
data currently on the data cartridge.
– 24 to 27
Emergency Reset 27 to 30
Revert back to normal mode – – – – 30+
Key
– Off
On (orange or green)
Blinking Unchanged from previous condition