For more information,
visit our Web site at
www.quantum.com
United States of America
Quantum Corporation
Storage Solutions Group
141 Innovation Drive
Irvine, CA 92612
U.S.A.
phone 949.856.7800
fax 949.856.7799
© 2004 Quantum Corporation. All rights reserved. DLTtape, the DLTtape logo, Quantum, the Quantum logo, SuperDLTtape, the Super DLTtape logo, and SuperLoader are trademarks of
Quantum Corporation registered in the U.S.A. and other countries. Products mentioned herein are for identification purposes only and may be registered trademarks or trademarks of their
respective companies. All other brand names or trademarks are the property of their respective owners.
Europe
7 Lindenwood
Chineham Business Park
Basingstoke, RG24 8QY
United Kingdom
phone +44 1256 818300
fax +44 1256 848700
Asia Pacific
Level 3
200 Creek Street
Brisbane, Qld 4000
Australia
phone +61 7 3839 0950
fax +61 7 3839 0955
Page 2
SuperLoader Drive Carrier Assembly (DCA) Replacement
Quick Start Guide
Step 3:
Remove the Current DCA
Note:
Before you remove the DCA,
make sure the
tape drive does not contain a tape cartridge.
For
instructions about unloading a cartridge from the tape
drive, refer to the User’s Guide.
a.
Turn off the SuperLoader using the front panel button.
b.
Disconnect all cables from the back of the DCA.
c.
Remove the four screws that secure the DCA to the chassis at
the rear of the SuperLoader.
Caution:
While removing or handling the SuperLoader
DLT DCA, do not touch the exposed printed circuit
board assembly on the underside of the unit.
d.
With one hand, grasp the DCA handle and slide the DCA out
while supporting it from underneath with your other hand.
e. Set the DCA
Screws
DCA bay
DCA
Handle
e.
Set aside the DCA you just removed.
Note:
The DCA must be returned to Quantum in the
replacement DCA packaging within 7 business days.
For further information, refer to the return material
authorization (RMA) instructions shipped with the
replacement DCA.
Step 4:
Install the Replacement DCA
Caution:
While removing or handling the SuperLoader
DLT DCA, take appropriate ESD precautions to prevent
accidentally touching or damaging the exposed
printed circuit board assembly on the underside of
the unit.
a.
Remove the replacement DCA from its antistatic packaging.
b.
Grasp the DCA by the handle with one hand and support the
underside of the DCA with the other hand.
c.
Slide the DCA into the DCA bay. Make sure you position the
DCA correctly; it should slide smoothly into the bay.
d.
Install the four screws (included with the replacement DCA)
to secure the DCA to the SuperLoader chassis. Tighten the
screws firmly.
e.
Make sure that the AC power switch on the back of the DCA
is off. Then, connect the power and SCSI cables.
f.
Turn on the SuperLoader by pressing the AC power switch at
the back of the unit. Verify that the SuperLoader is operating
properly.
Note:
On all SuperLoaders, SCSI terminators must be
used for proper operation of the drive.
81-81264-01 A01 Rev. August 2004
6207947-07cN 01