Quantum SuperLoader 3: Rackmount Replacement
6-68061-01 Rev A
December 2013
4
Removing the SuperLoader 3 from the Rackmount
displayed on the LCD,
Power Off
is displayed, and then the SuperLoader 3
shuts off.
3
Disconnect the cables and power cords.
Note:
Label the cables so that you can reconnect them to the correct
ports.
Removing the SuperLoader 3 from the Rackmount
Caution:
Retain all the parts removed in this procedure. Depending on what
parts of the rackmount are replaced, you may need to reuse some
parts.
WARNING:
At least two people are required to safely remove the
SuperLoader 3 from the rack cabinet. Failure to take this safety
step may result in personal injury or equipment damage.
When the SuperLoader 3 is rack mounted directly to the stationary cabinet rails,
complete the following steps to remove it.
Removing the
SuperLoader 3 From a
Rackmount
These instructions explain how to remove the SuperLoader 3 from a rackmount.
Required Tools:
• #2 Phillips screwdriver.
While the other installer holds the front end of the SuperLoader 3, remove it
from the rack by completing the following steps:
Note:
Before removing the SuperLoader 3 from the rack, you will need to
loosen the screws just enough to hold the support brackets firmly
against the rail while still allowing the support bracket to be slightly
shifted by hand. This shifting will help facilitate the removal of the
SuperLoader 3 brackets as the SuperLoader 3 is uninstalled from the
rack.
1
Loosen the four (4) screws that connect the two (2) support brackets to the
two (2) SuperLoader 3 brackets. Do not remove the screws completely at
this time (see
