Quantum Sun StorEdge L100, User Manual

Page: 81 / 192

Chapter 3 Changing the Library Configuration
Changing the Off-Line Time Setting
Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide 65
Changing the Off-Line Time Setting
3
When you access the
Menu
screen using the GUI, the library
becomes NOT READY and will not respond to any SCSI
commands issued. If you leave the library unattended in menu
mode, the library goes back to a READY state after a pre-set
time-out, controlled by the
Off-Line Time
option. You can set this
time-out to any value from 1 to 99 minutes, or turn it off.
To set the
Off-Line Time
:
1
Access the
Configuration
screen (see Accessing the
Configuration Screen on page 53).
2
Press the
Up
or
Down
buttons until
Off-Line Time
is highlighted.
3
Press
Select
.
4
Use the
Up
or
Down
buttons to select the desired
Off-Line Time
setting. The available settings are
1
through
99
and
Disabled
.
5
Press
Select
.
To return to the
Configuration
screen without changing the
option setting, press
Cancel
.
6
Press
Main
to return to the main screen.
Note:
The default setting is
Disabled
.
Caution:
If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.