StorNext QM1200, QS1200 or QS2400 Base System - Replacing a Controller
April 2015
Quantum Corporation
- 8 -
c.
Slide the battery towards the front of the controller canister, making sure that the battery slides under the
side guide pins to correctly seat it against the back surface of the controller.
6.
Engage the latch to secure the battery circuit board in the new controller card.
7.
Reinstall the top cover on the new controller by sliding it forward until the top cover latch buttons click.
Installing a Controller in the StorNext QM1200, QS1200 or QS2400 Base System
1.
Remove the controller air blocker from the controller slot.
2.
Slide the new controller (
) all the way into the base system.
Push the release lever towards the center of the controller to lock it into place.
Figure 8 Installing the Controller
1.
Release Lever
2.
Controller
ATTENTION
Make sure that the battery is fully seated and that the connectors are fully seated. If the
battery is not correctly seated, you cannot reinstall the top cover on the controller canister as directed
later. To make sure that the controller battery is seated correctly, you might need to slide it out and insert
it again. You know it is secure when you hear it click into place, and the locking handle does not move out
of its upright position when you wiggle it.
