Quantum QXS G2 Series, Hardware Installation And Maintenance Manual

Page: 37 / 246

System Overview 25
Refer to Figure 28 for all the 5U84 Raid chassis CRUs with CNC controllers.
Figure 28
5U84 RAID Chassis Rear View (CNC Controllers)
CNC FC/iSCSI Controller
Callout 1, Figure 28 , is the Controller A location. Callout 2 Figure 28 , is the Controller B location. Both
controllers are shown in the closed/locked position.
Figure 29 provides a rear view of the CNC FC/iSCSI controller used in the 5U84-drive systems. You can
configure the CNC host interface ports (Ports 0, 1, 2 and 3) with 8/16Gb/s FC SFPs; 10GbE iSCSI SFPs;
or 1Gb/s RJ-45 SFPs.
Figure 29
CNC FC/iSCSI Controller
1
2
3
4
5
6 7
8 9
1
Controller A 2 Controller B 3 Fan 0
4 Fan 1 5 Fan 2 6 Fan 3
7 Fan 4 8 PSU 0 9 PSU 1
2 3 4 5
1
6
7
8
9
10