8
DVB-T Daily Use
v
v
v
How to switch the receiver on
How to select a channel
Teletext
Depending on the specific car installation, the receiver will
be switched on as soon as the car key turns on the battery.
In case an external a/v source was previously activated,
please use the [ ] button on the remote control
to exit
stand-by mode.
A Tv or Radio channel can be selected in three different
modes:
[
] and [
]
[OK]
INFORMATION BAR will be previewed on the screen
tuning.
DIRECT
directly
trough the channels without using the [OK]
button.
If the relevant digital service includes Teletext informa-
tion, an OSD emulation of the Teletext home page will be
displayed (page nr.100).
All available pages can be accessed selecting relevant
number (using digits buttons) from the remote control.
(*) applicable only to Q100T model
• DIRECT: select the desired channel by using the numeri-
cal buttons
• ARROWS ZAPPING: select the desired channel by using
the up/down buttons
and press
to
confirm the selection.
before the channel
•
ZAPPING: press [P+] [P-]
to browse
5
6
5
6
(*)
.
• Press either the [Red] button. The option list will be
displayed
• From the list press [Green] for Teletext OR using the-
up/down buttons [
] and [
] select Teletext, press
[OK]
15 Channel TV
rogram
P
title
TV
12:17
12:00
12:45
SCAN
A/V
OK
P+
P
V+
CHANNEL
1
2
3
4
5
6
7
8
0
9
EXIT
BACK
MUTE
LIST
info
MENU
TV
RADIO
@ ? ! .
a b c
g h i
j k l
m n o
p q r s
t u v
_ + *
w x y z
d e f
21
Installation and Connections
TV ANTENNAS
Recommendations
active antennas that are
ly and
receiver’s
s. The antenna should be
for the
.
v
•
•
•
the
is
ed
test various positions
s,
•
with care
•
INSTALLATION GUIDELINES
Use only
amplified
adequate
directly powered by the
antenna connector
suitable
reception of the Digital Terrestrial signal
Quantum Antennas are manufactured and linked to
the Q100 receiver in order to optimize performance
.
Be sure to position the antennas as far away and
opposing from each other as possible. For exam-
ple, place the first antenna on the right side of the
wind screen of the vehicle
and the second one
on the left side of the rear window
or on the left
rear vent wing .
Antennas must be installed as far away from the
metal parts (vehicle's roof or vertical borders of
the wind screen/rear vent wing) as possible.
The bonnet or the boot (depending on the vehi-
cle) can influence
signal reception. It
rec-
ommend
to
to place the
antenna whether on the higher or the lower part
of the window. The higher part usually guarantees
more protection from noises caused by motorcy-
cles and scooters.
Handle the coaxial cable setting
in order
to avoid damages due to vibration or crushing.
Be sure that the connections have been correctly
set and check the screwing of the connectors. Sig-
nal reception problems are often caused by incor-
rect assembly.
WARNING: ONLY use the Quantum antenna
provided. Use of different antenna or other
external power may result in product damage
and might affect the warranty terms