11
NOTE: If the left turn indicator is activated, pressing the right indicator button will turn off the left
indicator and activate the right indicator.
NOTE: The turn indicator buttons also control the hazard lights. Press both turn indicator buttons
at the same time to activate the hazard lights and press both buttons again to turn off the hazard
lights. If the hazard lights are left on and the controller is turned off, the hazard lights will continue
to flash. The Q-Logic 2 must be turned back on and both turn indicator buttons must be pressed
to deactivate the hazard lights.
LCD Screen
The Q-Logic 2 provides the user with easily intuited feedback information via the LCD screen. The circle
at the bottom middle of the screen represent a stoplight. A green light indicates full drive operation, an
amber light indicates limited drive operation, and a red light indicates that drive operation is prohibited.
Drive Screen
The LCD provides the current time in either 12- or 24-hour clock format, the current profile, drive operation,
the speed adjustment setting, the trip odometer, and the overall odometer reading.
Drive/Function Inhibit status is depicted as a green light in lower center of the screen. Actuator adjustment
will affect the inhibit status. As your seat and/or back angle increases, a red light will indicate full drive
lockout. If your power chair is equipped with a seat lift, a yellow light will indicate speed reduction as the
seat is elevated. To return your power chair to green status, reverse operation.
Drive Profile Selection
Your Q-Logic 2 Controller may be programmed for up to five drive profiles that allow the system to be
custom-tailored to your environment. The drive profile may be changed two different ways. Profiles 1-5
may be selected by pressing the On/Off and Mode Select Lever in the forward direction. Profile 1 may be
selected by simply pressing the Key 1 select button. The selected profile is displayed on the Drive Screen.
NOTE: Drive profiles are set by your Quantum Rehab Provider. Contact your Quantum Rehab
Provider to change or add a drive profile.
To select a profile setting using the On/Off and Mode Select Lever:
1. Push the On/Off and Mode Select Lever up once to power on the chair and the controller.
2. Push the On/Off and Mode Select Lever up again to select a drive profile. Continue to cycle through the five
available drive profiles.
NOTE: You can only scroll forward through the drive profiles. Pushing the On/Off and Mode Select
Lever down will power off the controller.
WARNING! Drive/Function Inhibit status is read-only in your actuator adjustment (seat screen).
This function is disabled in drive mode in order to prevent unintended loss of function in your
power chair. Take caution when negotiating obstacles, ramps, and inclines. Whenever possible,
utilize an attendant in these conditions.
WARNING! Operating your power chair on inclines and/or with tilt/recline function will affect your
power chair’s stability.
To operate the turn indicators:
1. Push the On/Off and Mode Select Lever up once to power on the chair and the controller.
2. Press the desired turn indicator button once to turn on that indicator.
3. Press the same turn indicator button again to turn off that indicator.
Summary of Contents for q-logic 2
Page 1: ...Basic Operation Instructions...
Page 30: ...30 Notes...
