Appendix C Automatic Drive Cleaning
Selection of Cleaning Mode
100
Quantum|ATL P3000 Series User’s Guide
• Determining when a cleaning cartridge has used all 20 of its
available cleaning cycles
• Moving used up cartridges to the load port
Automatic Drive
Cleaning Mode
3
Automatic drive cleaning is disabled by default. In automatic drive
cleaning mode the
library
is responsible for all cleaning functions
such as:
• Detecting when a drive requires cleaning
• Tracking and selecting cleaning cartridges
• Moving a cleaning cartridge to the drive
• Determining when a cleaning cartridge has used all 20 of its
available cleaning cycles
• Moving used up cartridges to the load port
Selection of Cleaning Mode
3
The cleaning mode is selectable from the:
• Diagnostic software
• GUI
• Mode Select command
The default cleaning mode is host-initiated. A Mode Select
command permanently changes the cleaning mode in the library’s
NVRAM, and is retained if the library power is cycled.
Diagnostic
Software
3
To change automatic cleaning mode from the diagnostic software
select
Config
:
•
Enable clean tape
- turns automatic cleaning mode on
•
Disable clean tape
- turns automatic cleaning mode off
Summary of Contents for P3000 Series
