Quantum MC300 Prism, User Manual

Page: 90 / 140

Chapter 6 Fibre Channel Management
Bridge Administration
74 MC300 Prism Management Card User’s Guide
4
Click
Apply
.
A
Results
page displays indicating the data rate was
configured.
Setting the Fibre
Channel Loop ID
6
To configure the Fibre Channel loop ID:
1
Access the
Bridge Administration
page.
In the Navigation frame, under
Fibre Channel Management
,
click
Bridge Administration
.
2
Under
Set Fibre Channel Loop ID
, select a bridge from the
Bridge
pull-down list.
3
Enter the desired
Loop ID
for the selected bridge.
4
Click
Apply
.
A
Results
page appears indicating the loop ID was configured.
Route Maps
6
To configure a Route Map:
1
Access the
Bridge Administration
page.
Note:
Reboot the FC420 bridge to utilize the new
connection mode (see Rebooting a Bridge ).
Note:
Enter a number between 0 - 125 for hard addressing
to the Fibre port. To disable hard addressing and use
soft addressing to the Fibre port, enter 255.
Note:
Reboot the FC420 bridge to utilize the new loop ID.
Note:
You can only map a device to a Fibre port (LUN) location
that is offline.