Quantum MC300 Prism, User Manual

Page: 92 / 140

Chapter 6 Fibre Channel Management
Bridge Administration
76 MC300 Prism Management Card User’s Guide
A
Results
page displays indicating the SCSI device was
configured.
Options
6 This option allows you to enable or disable the ExtendedCopy
(XCopy) feature. Enabling ExtendedCopy allows data being
transferred directly from the hard disk to tape cartridges without
involving application servers except to initiate transfers and to
received reports of data transfer results (also known as Serverless
Backup). To change the ExtendedCopy setting:
1
Select a bridge from the
Bridge
pull-down list.
2
Select an action from the
Action
pull-down list.
The choices are
Enable
or
Disable
.
3
Click
OK
.
A
Results
page appears indicating the change has been made.
Rebooting a
Bridge
6
To reboot one or all bridges:
1
Access the
Bridge Administration
page.
In the Navigation frame, under
Fibre Channel Management
,
click
Bridge Administration
.
2
Select a specific bridge or
All
from the
Bridge
pull-down list.
3
Click
OK
.
Caution:
Refreshing the map resets all SCSI devices on the
bus. Therefore, do not use this feature when
active backup and restore jobs are running.
Note:
Reboot the FC420 bridge to utilize the new setting.
Note:
The bridge takes approximately 30 seconds to reboot.