Chapter 3: Installation
Verify the Shipment
Quantum LTO-5 HH SAS Model C User’s Guide
23
1
Inspect the unit for shipping damage. If there is damage, do not
install the unit. Report the damage immediately by contacting your
place of purchase.
2
Locate the label on the rear panel of the unit with the machine type,
model number, and serial number of the unit. Make a note of these
numbers and store them in an easily accessible place. Should you
need to contact Technical Support, you will be asked for these
numbers.
Verify the Shipment
Ensure that the following items are included in the shipment:
• Power cord
• Quantum LTO Ultrium Cleaning Cartridge
• Single-connector SAS wrap tool
• Optional Rack Mount Kit
• The Quantum System Storage LTO-5 Tape Drive Quick Reference
(6-68101-01)
• The Quantum System Storage LTO-5 Tape Drive Setup, Operator and
Service Guide 6-68131-01 (this guide)
• SAS cables are not part of the ship group. They must be ordered
separately.
Inspect the Power Cord and Outlet
1
Inspect the power cord plug to ensure that it matches the power
receptacle.
2
Ensure that all associated electrical outlets are properly grounded
and that the circuit breaker is turned on.
Summary of Contents for LTO-5 HH SAS C
