14
I8
Digital proportional radio control system
4.5 Calibrating the Sticks and Knobs
After switching the stick modes, it is required to calibrate the sticks and knobs on the transmitter. You
should also perform a calibration after switching sticks or if the transmitter sticks/knobs are not working
accurately.
To perform a calibration:
1. Move the left stick to the top right corner and the right stick to the top left corner, and slide the
power switch up to the ON position simultaneously. The status indicator starts to flash.
2. Move the sticks and knobs through their maximum range of movement.
3. Wait until the status indicator stops flashing. The calibration is finished.
4.6 Throttle Trim
For motor-driven models, it is required to set the initialization position of the throttle before first use.
1. Push the power switch up to the ON position.
2. Press and hold the throttle trim button upward or downward until you hear a beep of a higher tone.
4.7 Power Off
Follow the steps below to turn off the system:
1. Disconnect the receiver from the battery.
2. Slide the power switch of the transmitter down to the OFF position.
Danger
•
Make sure to disconnect the receiver battery before turning off the transmitter.
Or it may lead to unintended operation and cause an accident.
4.8 Switching the Channel Output Sequence
Generally the transmitter outputs channel signals in a sequence of CH1 -> CH2 -> CH3 -> CH4 -> CH5 ->
CH6 -> CH7
-> CH8. If needed, you can change the sequence to CH1 -> CH2 -> CH3 -> CH4 -> CH5 ->
CH7 -> CH6
-> CH8.
To switch between the two sequences:
1. Turn off the transmitter.
2. Move both of the sticks to the top left corner, and slide the power switch up to the ON position
simultaneously.
The sequence is now set and will not change unless the above procedure is performed again.