Quantum Dynamo ATS/RevA/Apr04
www.quantumrehab.com
21
I V . D I S A S S E M B L Y A N D A S S E M B L Y
To remove the seat:
WARNING! Depending on your lifting ability, Pride
recommends that two people remove the seat to
avoid possible damage to the seat or your power
chair.
1. Remove the four (4) T-handle ball detent pins securing the seat to
the power base.
2. Allow the seat to rest on the seat mount connectors.
3. Lift the seat directly up. See figure 13. You may find it necessary
to rock the seat gently from side to side to free the seat posts from
the seat mount connectors.
WARNING! Do not pick up the seat frame by the
armrests. They may be free to pivot, and you may
lose control of the seat if they do so, resulting in
personal injury or damage to the chair.
To remove the swing-away leg rests:
1. Press and hold the locking lever to unlock the leg rest. See figure
14.
2. Swing the leg rest to the side, then lift it straight up to remove it
from the mounting bracket.
Figure 14. Removing the Swing-away Leg Rest
Figure 13. Removing the Versa Seat
SEAT POST
SEAT MOUNT
CONNECTOR
LOCKING LEVER
Figure 15. Removing Battery Boxes
To remove the battery well frame:
1. Disconnect both battery connectors and both motor connectors.
See figure 7.
2. Lift and remove each battery box. See figure 15.
3. Squeeze together the latch release levers that hang vertically down
from the crossbar at the rear of the battery well frame. Lift up the
rear end of the battery well frame. See figure 16. Pull it to the rear
of the chair to release the front slots from the locating pins on the
front frame bottom bar.
To disassemble the right and left power base frame assemblies:
1. Stand behind your power chair and grasp one of the power base
frame assembly handles. See figure 17.
2. Press the chrome latch release lever toward the centre of the frame
and hold it. See figure 17.
3. Push the frame assembly outward and pull up on the front frame
until the latching mechanism releases.
4. Keep pulling upward until the locating pin on the bottom of the
front frame releases from its slot in the power base frame assembly.
5. Carefully let the power base frame assembly tilt to a resting position.
6. Repeat for the other power base frame assembly.
BATTERY WELL
FRAME
