Quantum DXi6902, Field Service Manual, Page: 193 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Array or Expansion Module Power Supplies
Quantum DXi6902 User’s Guide 169
Figure 101 DXi6902 Array
Module (RBOD) or Expansion
Module (EBOD) Power Supply
Replacing an Array or
Expansion Power
Supply
This section describes how to remove and replace a power supply in a
DXi6902 Array module (RBOD) or Expansion module (EBOD). If a power
supply fails, you will be notified by a service ticket in the remote
management console.
Caution: Use appropriate ESD precautions, including the use of a
grounding strap, when performing this procedure.
Removing and replacing a power supply in an Array module (RBOD) or
Expansion module (EBOD) includes the following steps:
• Identifying a Failed Power Supply in an Array or Expansion Module
• Removing a Failed Power Supply from an Array or Expansion Module
• Installing a Replacement Power Supply in an Array or Expansion
Module
Identifying a Failed Power Supply in an Array or Expansion
Module
The DXi6902 Array modules and Expansion modules each contains two
hot-swappable power supplies (see Figure 102 ).
Illustration Description
Replacement power
supply for DXi6902 Array
module (RBOD) or
Expansion module
(EBOD)
(585 watt)
PN 9-02213-01