Quantum DXi6902, Field Service Manual

Page: 137 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Node Expansion Cards
Quantum DXi6902 User’s Guide 113
9 In the remote management console, delete any administrative alerts
and close any service tickets.
Replacing an Expansion
Card in Riser 2 or 3
This section describes how to remove and replace an expansion card in
expansion card riser 2 or riser 3. The following cards are located in riser
2 or riser 3 (see Figure 59 ):
• Expansion Card Riser 2
• Slot 4 (top) - No card
• Slot 5 (bottom) - Quad port 6 Gb SAS card (LSI 9201-16E)
• Expansion Card Riser 3
• Slot 6 (top) - Quad port 6 Gb SAS card (LSI 9201-16E)
• Slot 7 (bottom) - Quad port 8 Gb Fibre Channel card (Qlogic
QLE2564)
Caution: Use appropriate ESD precautions, including the use of a
grounding strap, when performing this procedure.
Removing and replacing an expansion card in expansion card riser 2 or
riser 3 includes the following steps:
• Removing an Expansion Card from Riser 2 or 3
• Installing an Expansion Card in Riser 2 or 3
Removing an Expansion Card from Riser 2 or 3
To remove a failed expansion card from riser 2 or 3:
1 Shut down the system (see Turning On and Shutting Down the
System on page 21).
2 Remove the Node cover (see Opening and Closing the Node on
page 74).
3 Disconnect any cables connected to the expansion card.
4 Holding the touch points, lift the expansion card riser 2 or 3 from
the riser connector on the system board (see Figure 63 and
Figure 64 ).