Chapter 10: Utilities
Analyzer
Quantum DXi6900 User’s Guide
362
Figure 233:
Performance Page
To perform network analysis:
1. In the
Target IP Address
box, enter the IP address of the system to perform network analysis with.
The target system must have NetServer enabled (see
).
2. Click
Start
.
The throughput result is displayed under
Result From Last Run
in MB/s.
Note:
It takes approximately 5 seconds to refresh the results.
Settings
The
Settings
page allows you to enable or disable NetServer on the DXi6900. NetServer must be enabled
on the target DXi6900 system to perform network analysis with the system (see
).
To access the
Settings
page, on the
Network Analyzer
page, click the
Settings
).
Figure 234:
Settings Page
To enable or disable NetServer on the target DXi6900:
1. Select
Enable NetServer
to enable NetServer.
Or select
Disable NetServer
to disable NetServer.
