Chapter 9: Configuration
Replication Configuration
Quantum DXi6900 User’s Guide
272
l
When configuring segmented network interfaces, if the source DXi replication, data, and
management interfaces are on the same subnet, you must add a host route on the source DXi to
make sure the replication interface is correctly selected when replicating data to the target DXi
(see
Understanding Interface Routing on page 313
).
5. Click
Apply
.
Note:
The new target is not automatically added to existing replication schedules. You must add or edit
scheduled events to schedule replication to the new target (see
).
Editing a Replication Target
Edit a replication target to change encryption options or the source IP address.
To edit a replication target:
1. Under
Target DXis
, select the target and click
Pause
to pause replication.
2. Select the target again and click
Edit
.
The
Edit Target Host
).
Note:
If you are editing a target, you cannot change the
Target Hostname or IP
.
Figure 169:
Edit Target Host
3. In the
Encryption
drop-down box, select the type of encryption to use when sending replication data to
the target system (
None
,
128-bit
, or
256-bit
).
Caution:
For encryption, select
None
or
128-bit
if you are sending data to a DXi running a system
software version prior to DXi 2.1 Software.
Note:
AES encryption options are available only if the Data-in-Flight license is installed (see
).
4. In the
Source IP Address
box, enter the IP address that is used to uniquely identify the source DXi to
the target. This may be different than the actual network IP address of the source DXi.
If the target system is at DXi 2.1 Software or higher, the
Source IP Address
field is not required. If the
target system is at DXi 2.0.1.x Software or below, then you must enter the IP address by which the
target system recognizes the source system. The default value is
0.0.0.0
.
