Initializing the Storage Arrays and Software
Quantum DXi6900 Installation Guide
55
The system displays information about attached Array Modules (RBODs) and Expansion Modules
(EBODS) (see
).
Make sure all of the installed RBODs and EBODs are detected. If one or more storage arrays are not
detected, resolve the issue before continuing (see
).
Figure 47:
PTO: Check NetApp Trays
Array: 1
Number Of Disk Drives: 24
Controller: A
Controller: B
EBOD: 0
ESM Canister: A (Left)
ESM Canister: B (Right)
External Storage is OK.
5. On the
Hardware Check Menu
, type the option for
Check HBAs
and press
<Enter>
.
The system displays information about all expansion cards installed in the Node (see
).
Note:
The expansion card display below is an example. The actual cards assigned to each PCI
slot will depend on the configuration option selected for the DXi (see
).
Make sure all of the installed expansion cards are detected. If one or more expansion cards are not
detected, or are detected in the wrong slots, resolve the issue before continuing (see
).
Figure 48:
PTO: Check HBAs
PCI Slot: 1, Intel Corporation Ethernet 10G 2P X520 Adapter (rev 01)
PCI Slot: 2, -
PCI Slot: 3, QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA
(rev 02)
PCI Slot: 4, -
PCI Slot: 5, LSI Logic / Symbios Logic SAS2116 PCI-Express Fusion-MPT SAS-2
[Meteor] (rev 02)
PCI Slot: 6, LSI Logic / Symbios Logic SAS2116 PCI-Express Fusion-MPT SAS-2
[Meteor] (rev 02)
PCI Slot: 7, QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA
(rev 02)
