Quantum DXi4701, User Manual

Page: 395 / 440

Chapter 10: DXi4701 Utilities
Analyzer
Quantum DXi4701 User’s Guide 369
1 In the Target IP Address box, enter the IP address of the system to
perform network analysis with.
The target system must have NetServer enabled (see
Settings on
page 369).
2 Click Start .
The throughput result is displayed under Result From Last Run in
MB/s.
Note: It takes approximately 5 seconds to refresh the results.
Settings
The Settings page allows you to enable or disable NetServer on the
DXi4701. NetServer must be enabled on the target DXi system to
perform network analysis with the system (see Performance on
page 368).
To access the
Settings page, on the Network Analyzer page, click the
Settings tab (see Figure 204 ).
Figure 204 Settings Page
To enable or disable NetServer on the target DXi4701:
1 Select Enable NetServer to enable NetServer.
Or select Disable NetServer to disable NetServer.