Quantum DXi4701, User Manual

Page: 280 / 440

Chapter 9: DXi4701 Configuration
Replication Configuration
254 Quantum DXi4701 User’s Guide
2 Select the target again and click Edit .
The Edit Target Host window displays (see Figure 141 ).
Note: If you are editing a target, you cannot change the Target
Hostname or IP .
Figure 141 Edit Target Host
3 In the Encryption drop-down box, select the type of encryption to
use when sending replication data to the target system ( None ,
128-bit , or 256-bit ).
Using 256-bit encryption (default) provides a stronger level of
security but may have an impact on system performance in some
situations. For best performance, if your data network is already
secured, you should select None for encryption.
Caution: For encryption, select None or 128-bit if you are
sending data to a DXi running a system software
version prior to DXi 2.1 Software.
4 In the Source IP Address box, enter the IP address that is used to
uniquely identify the source DXi to the target. This may be different
than the actual network IP address of the source DXi.
If the target system is at DXi 2.1 Software or higher, the
Source IP
Address field is not required. If the target system is at DXi 2.0.1.x
Software or below, then you must enter the IP address by which the
target system recognizes the source system. The default value is
0.0.0.0 .