Quantum DXi4701, User Manual

Page: 162 / 440

Chapter 6: DXi4701 Replication
Receive NAS
136 Quantum DXi4701 User’s Guide
The Snapshots List displays the following information about each
snapshot:
• Share Name - The name of the share.
• Source DXi - The hostname of the system that the snapshot was
sent from.
• Started - The time the most recent replication job was started.
• Finished - The time the most recent replication job finished.
• Status - The status of the most recent replication job (see
Replication and Synchronization Status on page 125). Click the
status to display detailed information about the most recent
replication job.
Note: Click a column heading to sort the rows in the table by that
column. Click the column heading again to reverse the sort
order.
Recovering a Share
Recover a NAS share if the source system is unavailable and you need to
access the share (for example, to continue performing backups). When
you recover a share, you select a received snapshot. The DXi4701 uses
the snapshot to recreate the share on the target system just as it was at
the point in time when the snapshot was saved.
Note: Before recovering a share, you must enable CIFS on the DXi (see
Windows Domain on page 211). Also, if the DXi is not using
Active Directory, you must configure at least one workgroup
user to own recovered CIFS shares (see Share Access on
page 214).
To recover a share:
1
On the target system, select a snapshot in the
Snapshots List
and
click
Recover
.
The
Recovered Share Name
page displays (see Figure 73 ).