Quantum DXi4510, User Manual

Page: 257 / 292

Chapter 10: DXi4000 Utilities
Analyzer
Quantum DXi4000 User’s Guide 233
Figure 130 Performance Page
To perform network analysis:
1 In the Target IP Address box, enter the IP address of the system to
perform network analysis with.
The target system must have NetServer enabled (see
Settings on
page 233).
2 Click Start .
The throughput result is displayed under Result From Last Run in
MB/s.
Note: It takes approximately 5 seconds to refresh the results.
Settings
The Settings page allows you to enable or disable NetServer on the
DXi4000. NetServer must be enabled on the target DXi system to
perform network analysis with the system (see Performance on
page 232).
To access the
Settings page, on the Network Analyzer page, click the
Settings tab (see Figure 131 ).