Quantum|ATL StackLink™ Installation Instructions
Document 6421009-03, Ver. 3, Rel. 0
November 2001
8
Installing the Top Mounting Tray Assembly
2
Adjust the position of the rear support arms on the top mounting
tray until the distance between the front and rear flanges is
approximately the same as the distance between the front and rear
mounting strips in the rack.
3
Replace the six screws and washers you removed in
and
finger-tighten them. Position the front and rear screws as far apart
as the slots allow. Position the third screw approximately in the
middle slot.
4
Position the top mounting tray assembly in the rack, referring to
for the correct orientation.
Figure 4 Securing the Top
Mounting Tray Assembly to
the Rack
Note:
Do not over-tighten the screws. You need to be able to
extend or retract the rear support arms slightly as you
install the top mounting tray assembly.
Note:
Position the front and rear flanges on the top mounting
tray outside of the rack rails.
FRONT
REAR