Quantum|ATL StackLink™ Installation Instructions
Document 6421009-03, Ver. 3, Rel. 0
November 2001
Installing the Libraries
17
d
Press the white button next to the left magazine access door
and open the door.
e
Notice the hole behind the magazine access door, at the lower
edge of the library (see
).
This hole provides access to the rack mount clamp screw.
Figure 14 Securing the
Library to the Rack
f
Insert a no. 2 Pozi-Driv screwdriver into the hole and turn the
rack mount clamp screw clockwise to tighten it fully.
As you tighten this screw, a lever protrudes from the side of the
library and presses against the rear side of the rack rail.
g
Repeat steps
through
to secure the right side of the library
to the rack.
h
Close the magazine access doors.
3
Repeat steps
through
to install additional M1500 library
modules below the first one.
4
Once all the libraries are installed, fully tighten the StackLink
vertical shuttle assembly (see
Note:
Install the libraries from the top of the StackLink
downward, leaving no space between the libraries. The
cable lengths are designed for libraries installed
immediately adjacent to one another.
Access hole
for rack mount
clamp screw