Quantum|ATL StackLink™ Installation Instructions
Document 6421009-03, Ver. 3, Rel. 0
November 2001
10
Installing the Bottom Mounting Tray Assembly
3
Replace the six screws and washers you removed in
and
finger-tighten them. Position the front and rear screws as far apart
as the slots allow. Position the third screw approximately in the
middle slot.
4
Position the bottom mounting tray assembly in the rack, referring
for the correct orientation.
Figure 6 Securing the
Bottom Mounting Tray
Assembly to the Rack
5
Secure the bottom mounting tray assembly to the rack, using eight
screws (YS41803) and washers (YS40404) provided in the StackLink
kit (see
).
6
Fully tighten the six screws and washers securing the rear support
arms to the sides of the bottom mounting tray.
Note:
Do not over-tighten the screws. You need to be able to
extend or retract the rear support arms slightly as you
install the bottom mounting tray assembly.
Note:
Position the front and rear flanges on the bottom
mounting tray outside of the rack rails.
Note:
If the rack has widely spaced mounting holes, it may not
be possible to use all four screws to secure the rear
flanges. If this is the case, one screw per side at the rear is
acceptable.
FRONT
REAR