Quantum ATL PowerStor L200 Series, User Manual

Page: 36 / 106

Chapter 2 Installing the Cartridge Tape Library
Connecting the Tape Library
20 ATL PowerStor L200 Series Library User’s Guide
Connecting the Tape Library
2
Complete the following procedure to connect the power cord and SCSI
signal cables to the library. Figure 16 shows the rear panel layout.
Caution: Verify that the library controller is connected to the same
type of SCSI bus as the drive on that bus. For example,
connect a single-ended library to a single-ended adapter
and a differential library to a differential adapter.
Figure 16 Tape Library
Rear Panel Cable
Connectors
To connect the tape library:
Procedure
1
Turn the library off.
2
Connect one end of the SCSI cable to the library controller SCSI
connector on the back of the library.
3
Verify that the SCSI bus is terminated properly.
Depending on the system configuration, the SCSI bus initiates at
the host, connects to the library controller, and then to any other
SCSI devices on the bus. It terminates at the last SCSI device on the
bus. SCSI cabling connections are shown in figure 17.
Library controller
SCSI connectors
Power switch
Power supply
Power connector
Internal drive
connectors
Loader window