Quantum Vibe
www.quantumrehab.com
37
V I . O P E R A T I O N
Light Key
The light key turns headlights/taillights on and off independent of other indicators.
WARNING! Power chair users are required to use their lights when visibility is restricted—day or
night. Failure to use the lighting system in periods of poor visibility may result in personal injury.
Hazard Key
The hazard key toggles both indicators at the same time. You can only cancel this by pressing the hazard key again.
Battery Condition Meter
The battery condition meter is located in front of the joystick. This is a 10-segment illuminated display that indicates that the
Remote Plus is powered on and also gives the status of the batteries, the controller and the power chair electrical system.
!
!
!
!
!
Red, yellow and green lights lit: Batteries charged; controller and electrical system OK.
!
!
!
!
!
Red and yellow lights lit: Charge batteries if possible; controller and electrical system OK.
!
!
!
!
!
Red lights only lit or slow flash: Charge batteries as soon as possible; controller and electrical system OK.
!
!
!
!
!
Rapid flash of lights: Indicates a fault in the controller or the electrical system.
!
!
!
!
!
Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you
get “ripple up and down of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on
the controller.
NOTE: If you still get “ripple up and down of lights,” contact your Quantum Rehab Specialist.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, remind-
ing you the batteries need to be charged immediately!
Speed Settings
The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting is
5. The settings are indicated by the number of lights that are lit on the speed setting indicator.
NOTE: The speed settings are preset at the factory. If your Quantum Rehab Specialist changes the order of these
settings, please make note of these changes. Contact your Quantum Rehab Specialist for more information.
To select a speed setting:
1. Press the on/off key to power on the remote.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the speed setting.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed setting.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the
forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
