Installation and Care Instructions
11
www.quantumrehab.com
Synergy Shape Back
6. Once the mounting brackets are in place, stand behind the chair and align
the bottom mounting block on the seatback with the mounting pin on the
bottom mounting bracket. Make sure to angle the seatback forward. See
figure 7. Rotate the seatback backwards until it clicks into place.
NOTE: The zipper on the cushion will face the rear of the seat.
To install the Synergy Shape Back on chairs
with T-slotted back canes:
WARNING! Prolonged exposure
to the mounting band may
cause skin irritation. Avoid
prolonged contact.
1. Locate the “L” or “R” label on the mounting
bracket. The bracket marked “L” is for use
on the left side and the bracket marked “R”
is for use on the right side. The right bracket
is shown in figure 6 for reference.
2. Hold the Synergy Shape Back up to the
desired height on the seat canes and make
note of where the mounting brackets will be
located.
3. Install the T-slot adapter as shown in figure 6.
4. Starting on one side, wrap the mounting band
of the top bracket around the back cane so
the mounting band is on the bottom. Fasten
the mounting screw into the receiver. See
figure 6.
5. Wrap the bottom mounting band marked for
that side around the back cane so the mounting
band is on the bottom. Fasten the mounting
screw into the receiver. See figure 6.
6. Repeat for the other side.
WARNING! Ensure the hardware
is tight.
SEAT CANE
MOUNTING BAND
RECEIVER
T-SLOT ADAPTER
MOUNTING SCREW
TIGHTEN
MOUNTING
SCREW
Figure 6. Mounting Bracket
Installation on T-slotted
Canes