34
www.quantumrehab.com
Vibe
Battery Condition Meter
The battery condition meter is located in front of the joystick. This is
a 10-segment illuminated display that indicates that the VSI is pow-
ered on and also gives the battery status, the VSI status, and the elec-
trical system status.
n
Red, yellow, and green lights lit:
Batteries charged; VSI and
electrical system OK.
n
Red and yellow lights lit:
Charge batteries if possible; VSI
and electrical system OK.
n
Red lights only lit or slow flash:
Charge batteries as soon as
possible; VSI and electrical system OK.
n
Rapid flash of lights:
Indicates a fault in the VSI or the
electrical system. Refer to Trouble Codes.
n
Ripple side to side of lights:
The joystick was not in the
neutral position when the controller was turned on. If you get
ripple side to side of lights, turn off the controller, allow the
joystick to return to the neutral position, then turn on the controller.
NOTE: If you still get ripple side to side of lights, contact
your Quantum Rehab Specialist.
NOTE: When the batteries approach a discharged state, the
first red light will begin to slowly flash, reminding you the bat-
teries need to be charged immediately!
Speed/Profile Keys
There are two keys that control either the speed or the profile. This depends on how your VSI was programmed. Press the
speed/profile increase key to increase the speed or change the profile. Press the speed/profile decrease key to decrease
the speed or change the profile. The speed/profile setting is displayed on the maximum speed/profile indicator. If your
power chair was programmed with a drive profile, contact your Quantum Rehab Specialist for more information.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the slowest
setting until you become familiar with your new power chair.
Actuator Keys and Actuator Lights (for optional equipment)
Actuator keys and actuator lights are used for optional equipment such as power elevating seats or power elevating leg
rests. For specific operation of the actuator keys and actuator lights, contact your Quantum Rehab Specialist.
Figure 22. VSI Controller Keypad
V I I I . O P E R A T I O N
