Quantum Dynamo ATS RevE/May03
www.pridemobility.com
21
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding
you the batteries need to be charged immediately!
Speed Settings
The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting is 5.
The settings are indicated by the number of lights that are lit.
NOTE: The speed settings are preset at the factory. If your authorized Pride provider changes the order of these
settings, please make note of these changes. Contact your authorized Pride provider for more information.
To select a speed setting:
1.
Press the on/off key to power on the remote.
2.
Press the mode key once.
3.
To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the speed
setting.
4.
To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed
setting.
5.
Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the
forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the remote keypad. Contact your authorized Pride provider for information on how to operate these accesso-
ries.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the
controller. See figure 14a. The socket may also be used for reprogramming the controller by using a Penny & Giles Program-
mer, should this be necessary. If you use an off-board charger, the charger current should not exceed 12 amps. Contact your
authorized Pride provider for more information.
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/program-
ming socket. See your authorized Pride provider for more information.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module at the back of the
power base. See figure 14a.
Power Module
Typically, the power module is mounted to the power base. The power module provides a power interface for the joystick
module. It routes the battery power to the motors and other powered accessories such as lights and power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a control and power
interface between the power module, the lights, and/or the power seat actuator.
Sleep Mode
Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off the main
power if the joystick is not moved in any direction for approximately five minutes. The battery condition meter lights on the
keypad indicate sleep mode by blinking once every five seconds. To restore power and continue, push the on/off key twice.
OPERATION
Summary of Contents for Quantum Dynamo ATS
Page 39: ......
