Pre-configuring Access Point in standalone Mode
AP default SSID is QN_XX: XX (where XX:XX= last four digits of AP MAC ID).
Connect QN_XX:XX SSID and enter AP default IP 169.254.1.1 in browser.
Click on
start configuration
.
Figure 1
Do IPv4 setup (WAN) by selecting required option DHCP, Static or PPPoE and
proceed for Next.
Select
Management Mode
as Standalone and click on
Next.
Admin can select AP operation mode as
Bridge
or
Router.
o
Bridge
(In this mode, device connects to a wired or wireless router via an
Ethernet cable)
o
Router
(
Gateway)
(In this mode, device connects to the internet directly and
shares internet access to multiple wired and wireless devices.
o
For
Operation Mode
-
Bridge
, select option and follow below procedure.
Configure
WLAN
(SSID) parameters and click on
Next.
Configuration Summary
screen will appear. Click on
Reconfigure
if
any changes required or click on
Finish
to complete the quick
configuration.
o
For
Operation Mode
-
Router
, select option and follow below procedure.
Configure
WLAN
(SSID) and
Local subnet
parameters and click on
Next
.
Configuration Summary
screen will appear. Click on
Reconfigure
if
any changes required or click on
Finish
to complete the quick
configuration.
