Quantum Design CM-C, User Manual

Page: 44 / 54

Section 6.4 Chapter 6
MultiVu and VSM Oven-Enabled Software VSM Oven Software
6-4
VSM Oven Option User’s Manual, Rev. A3 Quantum Design
May 2011
Figure 6-2. VSM Install wizard: Selecting the VSM operating mode
You can return to this page and change your operating mode during any part of the
VSM Install
wizard. However, if you want to change the operating mode after the
VSM Install
wizard has
ended, you must restart the wizard from the beginning.
The
Sample Coordinates
pages for the two versions of the VSM software also differ. As
shown in Figure 6-3, these pages display an oven heater stick instead of the VSM sample rod.
Note:
A green dot appears in the illustration after a scan has been completed. The dot indicates
the location of the sample on the heater stick.
Figure 6-3. The Sample Coordinates page for determining sample offset
On the last page of the VSM Install wizard for the oven mode is a test for electrical continuity of
the heater stick. Also, the system initiates high vacuum before completing the wizard.
Other than the above-mentioned changes to the
VSM Install
wizard, the same sample-installation
process is used in the standard and oven modes.