PART REPLACEMENT
Replacing the controller box
Cubiscan 325 Service Manual
3 6
4. Slide the center cover to the left so that you can
access the controller.
5. Use the Phillips screwdriver to remove the two
screws holding the proximity sensor in place. Refer
to
. The proximity sensor is located in the
front, right corner of the Cubiscan.
6. Twist the cable lock indicated in
. This will
release the cables.
7. Discard the damaged proximity sensor.
8. Screw the replacement proximity sensor in place.
9. Screw the proximity sensor cables together, make
sure to twist the cable lock so that the cables are
locked together.
10. Slide the center cover back into place and tighten
the thumb screws.
11. Power the Cubiscan 325 back on.
Replacing the controller
box
This section describes how to replace the controller. The
controller box is located on the right side of the
Cubiscan 325.
Items needed
–Small Phillips screwdriver
–5/16'' wrench
–Replacement controller box
Complete the following steps to replace the controller.
1. Power the Cubiscan 325 off and disconnect the
power cord.
2. Remove the two center cover thumb screws that are
located on the right side of the system.
3. Slide the center cover to the left so that you can
access the controller.
Figure 38
Proximity sensor cables
Figure 39
Remove center cover
Figure 40
Controller box
