Wireless LAN
User manual
28
Troubleshooting
(Continued)
In Windows 2000:
1. Check
the
Windows 2000 Diagnostics.
See if there is any conflict in the
resource
allocation or
the
I/O
Address, IRQ
allocations. If you find that the
IRQ
or
I/O Addresses
are already assigned
to some other devices, you must change that value.
I/O Address
needs 40h byte length.
2. Go to the
Control panel.
Double click on the
PCMCIA Card
and
you will see
WLAN Adapter.
Double clicking on that will show you the
Card Information,
driver name and the driver
file.
You
must confirm the name of the driver and the driver file as
"prismnic.inf"
and
"prismnds.sys".
If
you do not find the names listed above, there are some problems and the driver is not installed
properly. Reinstall the driver.
Note:
Check the PnP BIOS setup menu and select
no
in case of the
WLAN Adapter
installation.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example - use only shielded interface cables when
connecting to computer or peripheral devices). Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
