10
3
System Setup
Caution: If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
3.1
Components
To setup the Qube-Servo 3 system, you need the following components:
1.
Qube-Servo 3
2.
Inertia disc module (shown in Figure 3.1a)
3.
Rotary Pendulum module (shown in Figure 3.1b)
4.
Power supply with the following ratings:
•
Input Rating: 100-240 V AC, 50-60 Hz, 1.4 A
•
Output Rating: 24 V DC, 2.71 A
Note:
Only the power supply provided (AC-DC adapter by TRUMPower, model ATS065T-P240)
should be used with the Qube-Servo 3
5.
Power cable
Note:
Only the power cable provided should be used with the Qube-Servo 3
Caution: Precaution must be taken during the connection of this equipment to the
AC outlet to make sure the grounding (earthing) is in place, and that the
ground wire is not disconnected
6.
USB A to C cable
(a) Qube-Servo 3 with Inertia Disc Module
(b) Qube-Servo 3 with Pendulum Module
Figure 3.1 Qube-Servo 3 components
