3
QNET Physics and Dynamics
and NI ELVIS II Setup
The procedure to install a QNET Physics and Dynamics module on the NI ELVIS II is detailed in this section. The
NI ELVIS II components used in the installation procedure are located and marked by an ID number in Figure 3.1,
and described in Table 3.1.
Caution
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
3.1 QNET Physics and Dynamics Components
To setup the QNET Physics and Dynamics system, you need the following components:
1. QNET Physics and Dynamics PCB (shown in Figure 1.1)
2. Two
M4x22mm
screws to secure the QNET Physics and Dynamics PCB to the NI ELVIS II
3.2 NI ELVIS II Components
Figure 3.1: Components on NI ELVIS II
QNET PHYSICS AND DYNAMICS - User Manual
10
