Install all components on the same local Ethernet subnet!
© August 2020 Quanergy Systems, Inc., QPN 96-00031 Rev E
ISO 9001:2015 Certified
System Hardware
A rear panel allows a user to connect the QPU-L7 to a power source and to the network. Through the
network, the QPU-L7 has access to the LiDAR sensor and the Q
ORTEX
DTC client. When direct interaction
with the QPU-L7 is needed, the user may remote log in or attach accessories to front/rear ports.
QPU-L7 Rear Panel (top), Front Panel (bottom)
System Setup
(Referenced documents are listed on the previous page in the
Documents
section.)
1.
Connect the QPU-L7 to the same local Ethernet subnet that the Q
ORTEX
DTC client and LiDAR
sensors are on. The Ethernet (LAN) ports are at the rear of the QPU-L7.
2.
Connect the QPU-L7 to power at the rear of the QPU-L7.
3.
Press the power switch at the front of the QPU-L7 case so that the Power LED illuminates.
4.
From the Ubuntu® PXE Menu, select
0) Boot from local drive
, then log in (username
user
, password
letmein)
.
5.
Activate a license (see
Q
ORTEX
DTC User Guide
or
Q
ORTEX
DTC Quick Start Card
), open a terminal window, and
execute
reboot
. The server daemon starts up and persists without additional user intervention.
6.
Execute
ifconfig.
Note the IP address listed as
inet addr:x.x.x.x
for future use with the
Q
ORTEX
DTC client, as explained in the
Q
ORTEX
DTC User Guide
or
Q
ORTEX
DTC Quick Card.
Contact:
Quanergy Systems, Inc., 433 Lakeside Drive, Sunnyvale, CA 94085 | http://quanergy.com
•
For purchases made directly from Quanergy: contact [email protected] for any questions
•
For purchases from a third party (value-added reseller/system integrator): contact them for support
Power LED
Temp, HDD, and Digial I/O LEDs
Dual Mode DP, HDMI
ATX Power On/Off
Ethernet LEDs (2)
USB 3.0 (4)
DP1 Display Port
DC Power In
DVI-I Video
PS/2 Peripherals
LAN (2)
Serial (2)
Sound (2)
USB 2.0 (2)
External Fan Power
Remote On/Off
Remote Pwr Reset
USB 3.0 (2)
Drive Bay