XLS Library Installation Manual
4-1
4
Installing the LRM
This chapter provides instructions for setting up the LRM.
Required tools and equipment:
Obtain the following:
•
3/4-inch open-end wrench
•
Level
Procedure overview:
After you have unpacked the LRM and moved it to its intended
installation location, installing the LRM involves the following steps:
•
Extending the leveling feet (see
4.1
Extending the Leveling Feet
To extend the leveling feet, follow these steps:
1.
Locate the four leveling feet on the base of the LRM.
2.
Using a 3/4-inch open-end wrench, loosen one of the leveling feet by turning the
jam nut. See
.
CAUTION
Before installing the LRM, be sure that the library’s power switch is off
and that the power cord is not attached to the power connector.
Figure 4-1
Releasing a jam nut
Turn jam nut to
loosen leveling foot
Summary of Contents for XLS-810160
