1.
Introduction
1.1 Who Should Read This Manual
This
Technical Service Manual
is for Tape Library System (TLS) service personnel. It
describes the Maintenance Menu, the Private Menu and Field Replacement Units
(FRU's). It also contains troubleshooting procedures, instructions for removing and
replacing FRU's and after–maintenance testing procedures. Finally, Chapter 9 con-
tains the System Interconnect diagram.
The following topics are covered in the TLS-4000 Installation and Operation manual
(Qualstar document number 501370):
•
Unpacking Instructions
•
Control Panel
•
Menu System
•
System Configuration
•
System Operation
•
Preventative Maintenance
•
Repacking Instructions
For information about the SCSI interface, or other information outside the scope of
this manual, please refer to the appropriate documents listed below.
Subject
Document
Qualstar
Document
Number
SCSI Command Information TLS-4000 SCSI-2 Interface Manual
Installation and Operation TLS-4000 Installation and Operation Manual
Specifications TLS-4000
Fibre Channel Option Fibre Channel Option Installation and Operation Manual
Supported Tape Drives Product Information Note
Approved Data Cartridges Product Information Note
Barcode Label Specifications Product Information Note
SCSI-2 ANSI
X3.131-1994
N/A
SCSI SPI-2 Specifications ANSI
X3.302-1998
SCSI Parallel Interface-2 (SPI-2)
N/A
SCSI-3 ANSI
X3.253:199X
and Amendment AM1 to X3.253.1995
N/A
Table 1-1 Applicable Documents
501380 Rev. B
Introduction
1-1
